NIe ma lekko
znalazłem sporo opisów jak wymienić żarówkę ( kroki 1-4, o których pisałem wcześniej) ale... No właśnie, zawsze jest jakieś ale
W moim przypadku- golf VI z bi-xenonem-jest tu bardzo mało miejsca na jakikolwiek ruch żarówką nawet po odpięciu od kabla i odkręceniu z lampy, żarówka lata luźno ale ni cholery nie ma ustawienia żeby ją wyjąć.
Na vortex znalazłem taki opis :
So, installation was a bit tricky, even though I don't have very large hands. Very little space to work with. This was passenger side. Make sure the car's lights are out, and wear plastic gloves so you don't accidentally touch the glass of the bulb (if you do, wipe it off with a lint-free cloth, using alcohol or isopropyl).
When you remove the rubber cover, you see the back-side rectangular portion of the lamp. Note that the writing on it is right-side up. You can see the connector at the bottom, which has a metal sleeve on it that locks into a tiny whole in the lamp's socket. I was able to lift this sleeve up (out of the hole), but couldn't remove the connector in that position.
To remove the lamp, you turn it about 1/8 counter-clockwise, and then pull the lamp out. There isn't enough space to pull it out and lift it up vertically, but you can now easily remove the connector.
I found only one diagonal way to twist the lamp and finally get it out. 
DOSZEDŁEM DO TEGO MIEJSCA I NI CHOLERY NIE MOGĘ ZNALEŹĆ POZYCJI DLA ŻARÓWKI ŻEBY JĄ WYCIĄGNĄĆ- pionowo, poziomo, skos w każdą stronę
Remember which way you got it out, because getting the new one back in is even more difficult.
After you take the lamp out, you need to remove the plastic ring that locks the lamp into position. It consists of two semi-circles that you can open up: push the doubled-up plastic tab back, and the ring will open (there is a hinge on the opposite side). Now you can remove the ring in the area where the two small notches are, and it will come off easily.
Close the plastic ring over the new lamp, aligning the two notches with their matching tabs.
Now you have a choice of either (i) first attaching the connector, or (ii) first installing the lamp back. (ii) is probably easier, but since I couldn't get the connector off while the lamp was in place, with my hands, I decided on (i), which is absurdly difficult. Basically, the attached cable makes it yet more difficult to move the lamp back into its proper position. Again, I just found one diagonal way to get the lamp back into the hole - be careful not to scratch the top wires too much during the process. Center it correctly, in the same 1/8 turned position you got it out, press in, then turn 1/8 clockwise. Make sure it has caught the tread and sits tight. If you used method (ii), don't forget to connect the cable back.
Z tego co widzę
instrukcja z punktów 1-4 może pozostać na papierze.
Dziś spróbuję jeszcze raz ;] może tym razem razem z pomocą zimnego
ręce będą bardziej zwinne
jakos latwo poszlo 
ale fakt ze miejsca przy lampach malo a Ci ktorzy to projektuja to powinni potem w serwisach za kare sami je wymieniac 
Wiem wiem na zdjeciu wyglada, ze jest mnóstwo miejsca, otóż nie 
